Appearance
Wire routing
When you connect two components, NumaSim routes the wire automatically using a right-angle strategy: orthogonal segments with sharp corners. The routing is fixed — there is no router picker — so every circuit reads the same way.
What you get
- Right-angle segments. Every wire is composed of horizontal / vertical pieces that meet at 90° corners. No diagonals, no rounded corners.
- Vertex preservation. If you drag a segment or insert a vertex, the router re-routes through your bend on subsequent element moves — so your hand-edits survive.
- Grid-aligned endpoints. Both ends snap to the canvas grid, so wires always draw straight between adjacent components.
Drawing a wire
Press on a port and drag to another port, then release. To branch off an existing wire, hold Shift, press on the wire where you want the junction, and drag to a port or to another wire: the new wire starts from that point (a T-junction).
Editing a single wire
Click a wire to select it, then:
- Drag a segment to nudge the route.
- Drag a point on the wire to add a bend (a vertex).
- Double-click a vertex to remove it.
Double-clicking anywhere else on the wire names its signal instead; see Observables.
Buses are drawn with the Bus tool rather than as wires, and are edited from their own dialog and right-click menu. See Signal routing & buses.
Touch support
On touch devices the same gestures work with a finger: drag from a port to draw, drag a segment to move it, and double-tap where you'd double-click. Pinch-zoom the canvas to make narrow segments easier to grab.
See also
- The canvas — placing the components you connect.
- Observables — naming a wire records its signal.
- Signal routing & buses — From / GoTo, buses and three-phase wires.